We now have better documentation on how to use the 3D printer.
Here’s the icosahedron that Don created. The vertexes are printed on the 3D printer:
Posted in Member Blogs |
Notify me of follow-up comments by email.
Notify me of new posts by email.
I’ve tweaked the documentation a bit to make it clearer how to set the extrusion temperature. As it stood it implied that you just set the temperature in the Console Extruder 0 tab which is not correct (all this does is change the warm-up temperature–the extrusion temperature is on the M109/M104 command in the GCode).
As such I’m not sure Don’s extrusion temperature experiments are valid, if all he did was change the value in the console window.